Template:FMB Manual Geofence settings

FMB120 has 50 configurable Geofence zones and it can generate an event when defined Geofence zone border is crossed. Frame border is an additional border around Geofence zone used to prevent false event recording when object stops on the border of the area and records are made inside and outside the area because of GNSS errors. The event is generated only when both borders (Geofence and frame border) are crossed. See figure to the right for details: blue track is considered to have entered the area while red track is not.
Shape can be rectangle or circle as defined by user.
Priority of Geofence event is catogorized into low, high or panic levels. These levels define priority of event information that is sent to server. For more details about priorities look in I/O settings section.
Generate event allows to choose choose when record will be generated.
Eventual records controls where scenario status value appears – when disabled it will exist in each AVL record, and when enabled the value will be appended only to eventual records.
OverSpeeding helps to configure OverSpeeding scenarios separately for each different geozone. Regular OverSpeeding and geozones OverSpeeding function independently. If digital output control is enabled in regular OverSpeeding scenario, geozones OverSpeeding scenario will control it too. If device is in more than one geozone and OverSpeeding is detected in any zone then the digital output turns on. Digital output turns off only when OverSpeeding is not detected anywhere .

X1 is used to set geofence zone left bottom corner X coordinate (longitude) while Y1 is use to set Y coordinate (latitude).
X2 or R are used to set accordingly geofence zone upper right corner X coordinate (longitude) when Rectangular zone is used or radius of circle when Circular zone is used. Y2 sets geofence zone upper right corner Y coordinate (latitude) for a Rectangular zone.