Difference between revisions of "Test Dual Cam wiki"
From Wiki Knowledge Base | Teltonika GPS
| Line 13: | Line 13: | ||
*[[DualCam update procedure]] | *[[DualCam update procedure]] | ||
*[[DualCam Certifications & Approvals]] | *[[DualCam Certifications & Approvals]] | ||
| + | *[[DualCam Troubleshoot]] | ||
==Other camera related functionality== | ==Other camera related functionality== | ||
Camera is configured if all of these conditions are met: | Camera is configured if all of these conditions are met: | ||
Revision as of 08:25, 15 July 2022
Teltonika DualCam is connected to FMB125,FMC125 and FMB225, FMC225 devices using the RS232 interface.
- First Start
- Camera Manual
- DualCam Configuration
- DualCam Data Sending Parameters ID
- Data image/video review
- DualCam Firmware errata
- DualCam comunication protocol
- DualCam SMS commands
- DualCam update procedure
- DualCam Certifications & Approvals
- DualCam Troubleshoot
Camera is configured if all of these conditions are met:
- RS232 mode is selected (DualCam)
- Camera was not configured since startup or one of the related parameters were changed (compression, framerate or OSD)
- Camera file transfer is not active
Active camera reconfiguration is accompanied by two consecutive camera shutter clicks.
If camera is disconnected and later reconnected, a device will detect it by periodic camera ping packet. Once camera is detected, the device will reissue the reconfiguration procedure.
