From Wiki Knowledge Base | Teltonika GPS
|
|
| Line 14: |
Line 14: |
| | *[[DualCam Certifications & Approvals]] | | *[[DualCam Certifications & Approvals]] |
| | *[[DualCam Troubleshoot]] | | *[[DualCam Troubleshoot]] |
| − | ==Other camera related functionality==
| |
| − | Camera is configured if all of these conditions are met:
| |
| − |
| |
| − | #'''RS232 mode is selected (DualCam)'''
| |
| − | #'''Camera was not configured since startup or one of the related parameters were changed (compression, framerate or OSD)'''
| |
| − | #'''Camera file transfer is not active'''
| |
| − |
| |
| − | Active camera reconfiguration is accompanied by two consecutive camera shutter clicks.
| |
| − | If camera is disconnected and later reconnected, a device will detect it by periodic camera ping packet. Once camera is detected, the device will reissue the reconfiguration procedure.
| |
| − | <br>
| |
Revision as of 08:33, 15 July 2022
Teltonika DualCam is connected to FMB125,FMC125 and FMB225, FMC225 devices using the RS232 interface.
