Changes

no edit summary
Line 30: Line 30:  
* High – allows to choose High level for Data acquisition;
 
* High – allows to choose High level for Data acquisition;
   −
{{{image3|[[Image:FMB630_autoCAN3.png|center|700px]]}}}
+
{{{image3|[[Image:FMB630_autoCAN3.png|center|750px]]}}}
 
   
 
   
  CAN monitoring
+
''CAN monitoring''
    
To start CAN bus monitoring mark Monitoring check box. Table of available CAN messages will appear (Figure 103). Data from CAN bus will be updated every 3 seconds. In order to see only desired data open “Monitoring filters” menu.
 
To start CAN bus monitoring mark Monitoring check box. Table of available CAN messages will appear (Figure 103). Data from CAN bus will be updated every 3 seconds. In order to see only desired data open “Monitoring filters” menu.
   −
  Monitoring filters
+
''Monitoring filters''
    
Monitoring filters menu allows choosing which data will be shown in configuration menu. To enable/disable particular data monitoring use checkbox next to data name. To enable all data monitoring click Select all, to disable all data monitoring click Select none.
 
Monitoring filters menu allows choosing which data will be shown in configuration menu. To enable/disable particular data monitoring use checkbox next to data name. To enable all data monitoring click Select all, to disable all data monitoring click Select none.
    
Note: CAN monitoring is FMB630 configurator function; it does not enable data sending to server. In order to configure data sending to server refer to Configuration section.
 
Note: CAN monitoring is FMB630 configurator function; it does not enable data sending to server. In order to configure data sending to server refer to Configuration section.

Navigation menu