Revision as of 12:37, 5 March 2025

Wired accessories

Configurable CAN settings:

Baudrate selection:
- Auto - allows user to detect CAN bus baudrate automatically.
- Manual - allows user to select baudrate manually.

Nominal baudrate (kbps) - can be chosen only when Manual baudrate is used:
- Selection from 33 to 2000 kbps (10 possible values).

Data baudrate (kbps) - can be chosen only when Manual baudrate is used:
- Selection from 33 to 2000 kbps (10 possible values).
- Available only with FDCAN.

Termination resistor - allows to control 120 Ohm termination resistor:
- Disable
- Enable.

@@ Line 1: / Line 1: @@
 =Wired accessories=
-==1-Wire settings==
+<!-- If model supports Manual CAN, then show -->
-[[File:FTX 1-wire settings.png|alt=|right|500px]]
-Set up a sequence of 1-Wire sensors by your needs. This sequence affects how temperature values will be sent to the server using I/O elements.
 {{#switch: {{{model|FTC305}}}
 | FTC305
@@ Line 10: / Line 7: @@
 ==CAN==
 [[File:FTX CAN.png|alt=|right|500px]]
-CAN settings. Controls CAN speed, etc.
+Configurable CAN settings:
+*'''Baudrate selection''':
+**'''Auto''' - allows user to detect CAN bus baudrate automatically.
+**'''Manual''' - allows user to select baudrate manually.
+*'''Nominal baudrate (kbps)''' - can be chosen only when Manual baudrate is used:
+**Selection from '''33''' to '''2000 kbps''' (10 possible values).
+*'''Data baudrate (kbps)''' - can be chosen only when Manual baudrate is used:
+**Selection from '''33''' to '''2000 kbps''' (10 possible values).
+**Available only with FDCAN.
+*'''Termination resistor''' - allows to control 120 Ohm termination resistor:
+**Disable
+**Enable.
 }}
+<!-- TBD
+==1-Wire settings==
+[[File:FTX 1-wire settings.png|alt=|right|500px]]
+Configure the sequence of 1-Wire sensors as needed. This sequence determines how temperature values are sent to the server via I/O elements.
+-->