From Teltonika Telematics Wiki
|
|
| Line 10: |
Line 10: |
| }} | | }} |
|
| |
|
| <!-- If model supports CAN, then show -->
| |
| {{#if: {{FTX Pin Support List|model={{{model}}}|pin=CAN}} |
| |
| ==CAN==
| |
| [[File:FTX CAN.png|alt=|right|500px]]
| |
| Configurable CAN settings:
| |
|
| |
| *'''Baudrate selection''':
| |
| **'''Auto''' - allows user to detect CAN bus baudrate automatically.
| |
| **'''Manual''' - allows user to select baudrate manually.
| |
|
| |
| *'''Nominal baudrate (kbps)''' - can be chosen only when Manual baudrate is used:
| |
| **Selection from '''33''' to '''2000 kbps''' (10 possible values).
| |
|
| |
| *'''Data baudrate (kbps)''' - can be chosen only when Manual baudrate is used:
| |
| **Selection from '''33''' to '''2000 kbps''' (10 possible values).
| |
| **Available only with FDCAN.
| |
|
| |
| *'''Termination resistor''' - allows to control 120 Ohm termination resistor:
| |
| **Disable
| |
| **Enable.
| |
| }}
| |
| {{#if: {{FTX Pin Support List|model={{{model}}}|pin=1-Wire}} | | | {{#if: {{FTX Pin Support List|model={{{model}}}|pin=1-Wire}} | |
| ==1-Wire settings== | | ==1-Wire settings== |
Latest revision as of 14:16, 12 November 2025
Wired accessories
[[Category:{{{model}}} Configuration]]
