1,247
edits
Changes
Template:FMB2 Mounting recommendations (view source)
Revision as of 09:34, 24 May 2018
, 09:34, 24 May 2018no edit summary
* For better contact scrub paint from the spot where loop is going to be connected.
* For better contact scrub paint from the spot where loop is going to be connected.
</font>
</font>
==PAY ATTENTION!==
[[Image:attention.jpg|300px|center]]
Connecting the power supply must be carried out in a
very low impedance point on-board vehicle network. These points in the car are
the battery terminals. Therefore, we recommend connecting the power of
FMB2YX (wire GND and POWER) directly to the battery terminals. Another valid
option is to connect the wires to the main POWER cable inside the fuse box (if
there is none, then to the power supply where the fuses of vehicle’s computer
are), wire GND must be connected in a special point, designed to connect GND
vehicle computer. Connecting the GND at an arbitrary point to the mass of the
car is unacceptable, as static and dynamic potentials on the line GND will be
unpredictable, which can lead to unstable FMB2YX and even its failure.
<br /><br /><br /><br /><br /><br />
<font size="+3"><span style=color:#FF0000>'''Safety information'''</span></font><br/>
<font size="+3"><span style=color:#FF0000>'''Safety information'''</span></font><br/>