Template:FMB9 First start card: Difference between revisions

Revision as of 07:03, 6 May 2019

Small and smart tracker with Blue-tooth

How to insert Micro-SIM card

Insert Micro-SIM card as shown with PIN request disabled or

read our Wiki how to enter PIN later in Teltonika Configurator. Make sure that Micro-SIM card cut-off corner is pointing forward to slot.

Connect battery as shown to device.
Connect micro usb cable as shown
To power up TST100, connect green plug to the E-scooter
Open Teltonika configurator, select TST100 device and

configure it according to your requirements (how to install drives on page

Once all done, disconnect TST100 from PC and E-scooter. Attach

the lid by two screws as shown

Micro-SIM card insertion/removal must be performed when device is powered off – external voltage and internal battery disconnected. Otherwise Micro-SIM card might be damaged or device will not detect it.

@@ Line 31: / Line 31: @@
 | [[File:Alert.png|left|link=]] || <b>{{{sim_type|Micro-}}}SIM card insertion/removal must be performed when device is powered off – external voltage {{{battery|and internal battery}}} disconnected. Otherwise {{{sim_type|Micro-}}}SIM card might be damaged or device will not detect it.</b>
 |}
-=='''How to insert microSD card'''==
-# Push microSD card lock case.
-# Open microSD card locker.
-# Correctly insert microSD card into slot.
-# Close microSD card locker.
-# Push microSD card lock case to locked position.
-<b>NOTE:</b> SD cards are only used in devices manufactured until '''2018-04'''. Newer devices have internal flash memory.
-[[Image:Sd_card_1.png|x150px]] [[Image:Sd_card_2.png|x150px]] [[Image:Sd_card_3.png|x150px]] [[Image:Sd_card_4.png|x150px]] [[Image:Sd_card_5.png|x150px]]