Difference between revisions of "Template:FMB630 K-Line Data"
From Wiki Knowledge Base | Teltonika GPS
(Created page with "K-Line Data functionality allows user to monitor and use incoming data from Tachograph via K-line. Kline periodic record timeout paramater is used to set interval between K-Li...") |
|||
| Line 1: | Line 1: | ||
| − | K-Line Data functionality allows user to monitor and use incoming data from Tachograph via K-line. Kline periodic record timeout | + | |
| + | K-Line Data functionality allows user to monitor and use incoming data from Tachograph via K-line. Kline periodic record timeout parameter is used to set interval between K-Line records. Those records aren't included in standard record and will be sent as separate packet. | ||
To configure any K-Line parameter, every parameter should be separated with comma. | To configure any K-Line parameter, every parameter should be separated with comma. | ||
| Line 7: | Line 8: | ||
Other Kline properties can be configured in the same logic. | Other Kline properties can be configured in the same logic. | ||
| − | [[Image:kline_tab.png| | + | |
| + | |||
| + | [[Image:kline_tab.png|center]] | ||
| + | |||
| + | ==K-Line front panel supported with Firmware version 00.02.77 or lower== | ||
Revision as of 14:44, 12 July 2019
K-Line Data functionality allows user to monitor and use incoming data from Tachograph via K-line. Kline periodic record timeout parameter is used to set interval between K-Line records. Those records aren't included in standard record and will be sent as separate packet.
To configure any K-Line parameter, every parameter should be separated with comma. For example, configuring first profile Kline Driver 2 ID by SMS, SMS should look like: “ setparam 1062 1,,,3” (“ setparam 1062 <Priority>,<HighLevel>,<LowLevel>,<generateEvent>”) Driver 2 ID do not have High/Low level so they are skipped by using comma “,,“ Other Kline properties can be configured in the same logic.
