Difference between revisions of "Template:FMB1 First start card"
From Wiki Knowledge Base | Teltonika GPS
| Line 16: | Line 16: | ||
Device is ready to be installed. | Device is ready to be installed. | ||
| − | [[Image:{{{sim_insert_pic1| | + | [[Image:{{{sim_insert_pic1|FMB1_cover1_correct.png}}}|260px]][[Image:{{{sim_insert_pic2|FMB1_cover2_correct.png}}}|260px]][[Image:{{{sim_insert_pic3|FMB1_cover3_correct.png}}}|260px]][[Image:{{{sim_insert_pic4|FMB1_cover4_correct.png}}}|260px]] |
{| | {| | ||
Latest revision as of 17:50, 10 April 2020
GNSS/GSM/Bluetooth tracker with internal GNSS/GSM antennas
How to insert Micro-SIM card and connect the battery
- Gently remove FMB1YX cover using plastic pry tool from both sides.
Note: To properly open a new case please watch this video.
- Insert Micro-SIM card as shown with PIN request disabled or read Security info how to enter it later in Teltonika Configurator. Make sure that Micro-SIM card cut-off corner is pointing forward to slot. SIM slot 1 is closer to PCB, SIM slot 2 is the upper one.
- Connect battery as shown to device. Position the battery in place where it does not obstruct other components.
- After configuration, see “PC Connection (Windows)”, attach device cover back.
Device is ready to be installed.
 |
Micro-SIM card insertion/removal must be performed when device is powered off – external voltage and internal battery disconnected. Otherwise Micro-SIM card might be damaged or device will not detect it. |
