Difference between revisions of "MSP500 System settings"

From Wiki Knowledge Base | Teltonika GPS
m (Protected "MSP500 System settings" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite)))
Line 1: Line 1:
 
{{Template:FMB System settings
 
{{Template:FMB System settings
 
|model=MSP500
 
|model=MSP500
|template_link={{Template:FMB9 Movement parameters}}
+
|analog_input =
 +
|txt_din3 =
 +
|txt_fmb208_show =
 +
|txt_fmb208_enable =
 +
|input_mode =
 +
|voltage =
 +
<!---|template_link={{Template:FMB9 Movement parameters}}
 
|pic_system=[[File:MSP500 System settings v0.16.1.17313.png|800px|none]]
 
|pic_system=[[File:MSP500 System settings v0.16.1.17313.png|800px|none]]
 
}}
 
}}
'''Note:''' ''If record is without valid coordinates – (there were no GPS fix in the moment of data acquisition) – Longitude, Latitude and Altitude values are last valid fix, and Angle, Satellites and Speed are 0. After a reboot, it will send zero coordinates.''
+
'''Note:''' ''If record is without valid coordinates – (there were no GPS fix in the moment of data acquisition) – Longitude, Latitude and Altitude values are last valid fix, and Angle, Satellites and Speed are 0. After a reboot, it will send zero coordinates.''--->
 
[[Category:MSP500 Configuration]]
 
[[Category:MSP500 Configuration]]

Revision as of 02:25, 20 April 2020

Main Page > EOL Products > MSP500 > MSP500 Configuration > MSP500 System settings

{{Template:FMB System settings |model=MSP500 |analog_input = |txt_din3 = |txt_fmb208_show = |txt_fmb208_enable = |input_mode = |voltage =