Difference between revisions of "OBD Device Debugging"
From Wiki Knowledge Base | Teltonika GPS
BaronenasT (talk | contribs) |
BaronenasT (talk | contribs) |
||
| Line 6: | Line 6: | ||
* Enable [[Codec#Codec_8_Extended|'''Codec 8 Extended''']] Protocol | * Enable [[Codec#Codec_8_Extended|'''Codec 8 Extended''']] Protocol | ||
[[Image:Data_protocol.gif|230px]] | [[Image:Data_protocol.gif|230px]] | ||
| − | * Configure Ignition | + | * Configure '''Ignition Settings''' according to your vehicle. |
| + | If it is a vehicle equipped with Internal Combustion Engine, it is recommended to Keep Ignition Source settings with Power Voltage | ||
Revision as of 16:17, 14 July 2023
Solution applies for these devices
FMB001 FMC001 FMM001 FMB003 FMC003 FMM003
Basic OBD OEM Configuration
- You need to make sure that your vehicle is supported with OBD OEM parameters. Compatibility can be checked here: OBD Supported Vehicle List
- Enable Codec 8 Extended Protocol
- Configure Ignition Settings according to your vehicle.
If it is a vehicle equipped with Internal Combustion Engine, it is recommended to Keep Ignition Source settings with Power Voltage
