Difference between revisions of "OBD Device Debugging"
From Wiki Knowledge Base | Teltonika GPS
BaronenasT (talk | contribs) |
BaronenasT (talk | contribs) |
||
| Line 7: | Line 7: | ||
[[Image:Data_protocol.gif|230px]] | [[Image:Data_protocol.gif|230px]] | ||
* Configure '''Ignition Settings''' according to your vehicle. | * Configure '''Ignition Settings''' according to your vehicle. | ||
| − | If the vehicle is equipped with '''Internal Combustion Engine''', it is recommended to | + | If the vehicle is equipped with '''Internal Combustion Engine''', it is recommended to keep '''Ignition Source settings''' with ''Power Voltage''. Otherwise, if it is an '''EV/HV''', set '''Ignition Source settings''' as ''Accelerometer''. |
Revision as of 16:30, 14 July 2023
Solution applies for these devices
FMB001 FMC001 FMM001 FMB003 FMC003 FMM003
Basic OBD OEM Configuration
- You need to make sure that your vehicle is supported with OBD OEM parameters. Compatibility can be checked here: OBD Supported Vehicle List
- Enable Codec 8 Extended Protocol
- Configure Ignition Settings according to your vehicle.
If the vehicle is equipped with Internal Combustion Engine, it is recommended to keep Ignition Source settings with Power Voltage. Otherwise, if it is an EV/HV, set Ignition Source settings as Accelerometer.
