Changes

   If you have a vehicle that is not listed in the [[OBD_supported_vehicle_list|'''OBD OEM Supported Vehicle List''']] or you are facing problems with OBD OEM in General - follow the log capturing guide below.

   If you have a vehicle that is not listed in the [[OBD_supported_vehicle_list|'''OBD OEM Supported Vehicle List''']] or you are facing problems with OBD OEM in General - follow the log capturing guide below.

==== Capturing OBD logs from FMX00X with Filters ====

==== Capturing OBD logs from FMX00X with Filters ====

#Make sure that the FMX00X is [https://www.youtube.com/watch?v=RJllm9verYg&ab_channel=TeltonikaTelematics connected properly] to the OBDII Socket.

#Make sure that the FMX00X is [https://www.youtube.com/watch?v=RJllm9verYg&ab_channel=TeltonikaTelematics connected properly] to the OBDII Socket.

#'''Start vehicle engine'''.

#'''Start vehicle engine'''.

#Send following '''SMS commands''' to FMX1YX device:  

#Send following '''SMS commands''' to FMX00X device:  

#*If you have set SMS login and password:<code>login pass log2sdfilterset 0;2;3;4;1</code>  

#*If you have set SMS login and password:<code>login pass log2sdfilterset 0;2;3;4;1</code>

#*If SMS login and password are not set leave two spaces before command: <code><span style="color:#f8f9fa">aa</span>log2sdfilterset 0;2;3;4;1</code> <p>If command <code>log2sdfilterset</code> was sent correctly you should receive SMS Response:<code>Enabled Trace Filters:5</code> then you can restart the device</p>

#*If SMS login and password are not set leave two spaces before command: <code><span style="color:#f8f9fa">aa</span>log2sdfilterset 0;2;3;4;1</code> <p>If command <code>log2sdfilterset</code> was sent correctly you should receive SMS Response:<code>Enabled Trace Filters:5</code> then you can restart the device.</p>

# If FW version is <b>03.27.10</b> or higher <code>cpureset</code> command is not necessary to enable the filters. On lower versions <code>cpureset</code> is mandatory.

#*<p>If SMS login and password are not set leave two spaces before command:<code><span style="color:#f8f9fa">aa</span>cpureset</code></p><p>Filter description:</p><p>Filter 0 - default filters (No additional data)</p><p>Filter 4 - turn on CAN adapter filter</p><p>Filter 1 - save installed filters to memory after restart</p>

#After the SMS response message CAN adapter log capturing has been started.

#After the SMS response message CAN adapter log capturing has been started.

#Wait at least '''5 minutes''' to get enough CAN bus data and '''turn off''' vehicle engine.

#Wait at least '''5 minutes''' to get enough CAN bus data and '''turn off''' vehicle engine.