FMB920 Accessories
From Wiki Knowledge Base | Teltonika GPS
Revision as of 13:41, 3 May 2021 by 82.137.230.20 (talk)
Main Page > Basic Trackers > FMB920 > FMB920 Manual > FMB920 Accessories
![]() |
Please order accessories separately as they are not included into device package. |
Accessory and its description | Accessory connection schematic |
---|---|
Fuel tank sensors | Fuel sensor connection to FMB920 |
A fuel tank level sensor which indicates the approximate fuel level on the driver's indicator panel exists in most cars. If the sensor returns analogue signal proportional to fuel level it can be connected to FMB920 Analog input. After connection to the tank fuel level sensor a calibration is needed because most fuel tank sensors are not linear. Calibration is performed by measuring voltage values resulting from the volume of fuel in tank. | |
Alarm buttons, door sensors etc. | Panic button connection to FMB920 |
Alarm buttons, door sensors, ignition, etc. have two output states: high or low. FMB920 Digital inputs are used to detect these states. | |
Relays | Inverting relay connection to FMB920 |
In cases when sensor output signal is negative, an additional relay has to be installed to convert negative signal to positive. | |
Immobilizer relay | Immobilizer relay connection to FMB920 output |
When connected as shown on the right hand side, FMB920 disables engine starter when output is ON. | |
Automotive relay | Automotive relay pinout |
An ordinary automotive relay is used to invert input signal or to immobilize engine starter. Note that relays can be 12 V or 24 V capable. |