FMM250 CE / RED
The Radio Equipment Directive (2014/53/EU) ensures a Single Market for radio equipment by setting essential requirements for safety and health, electromagnetic compatibility, and the efficient use of the radio spectrum.
Description
It applies to all products using the radio frequency spectrum. It has been applicable since 13 June 2016. As of 13 June 2017 the new set of requirements of RED are applicable to the equipment.
According to RED directive, the conformity against the following requirements needs to be demonstrated:
- 3.1(a): Radio equipment shall be constructed so as to ensure the protection of health and safety of persons and of domestic animals and the protection of property, including the objectives with respect to safety requirements set out in Directive 2014/35/EU (LVD), but with no voltage limit applying;
- 3.1(b): Radio equipment shall be constructed so as to ensure an adequate level of electromagnetic compatibility as set out in Directive 2014/30/EU (EMC).
- 3.2: Radio equipment shall be so constructed that it both effectively uses and supports the efficient use of radio spectrum in order to avoid harmful interference.
Starting with 20 December 2020 only the EN62368-1 will be accepted as a proof of conformity for LVD part of CE RED requirements.
Standards applied
The conformity with the essential requirements has been demonstrated against the following harmonized standards:
| Harmonized Standard reference | Article of Directive 2014/53/EU | Test report No. |
| IEC 62368-1:2018
EN IEC 62368-1:2020 + A11:2020 |
Health and Safety - Article 3.1(a) | R2402A0113-L1 |
| EN 50665:2017
EN IEC 62311:2020 |
R2402A0113-M1 | |
| EN 55032:2015 + A11:2020
EN 55035:2017 + A11:2020 ETSI EN 301 489-1 V2.2.3 ETSI EN 301 489-17 V3.2.4 ETSI EN 301 489-19 V2.2.1 ETSI EN 301 489-52 V1.2.1 |
Electromagnetic compatibility - Article 3.1(b) | R2402A0113-E1 |
| ETSI EN 301 511 V12.5.1
ETSI EN 301 908-1 V15.2.1 ETSI EN 301 908-13 V13.2.1 ETSI EM 300 328 V2.2.2 ETSI EN 303 413 V1.2.1 |
Spectrum Efficiency –
Article 3.2 |
R2402A0113-R1
R2402A0113-R2 R2402A0113-R3 R2402A0113-R4 R2402A0113-R5 |
The conformity assessment procedure referred to in Article 3.1(a), 3.1(b), and 3.2 and detailed in Annex III Module B of Directive 2014/53/EU has been followed with the involvement of the following Notified Body: Eurofins Electrical and Electronic Testing NA, Inc. Notified Body No: 0980.
Therefore is placed on the product.