FM3001 First Start
From Wiki Knowledge Base | Teltonika GPS
Revision as of 08:46, 30 May 2018 by Simkunas.ma (talk | contribs)
Main Page > EOL Products > FM3001 > FM3001 First Start
Advanced Plug and Track real-time tracking terminal with GNSS, 3G and Bluetooth connectivity
How to insert Micro-SIM card
- Gently remove FM3001 cover using plastic pry tool from both sides.
- Insert Micro-SIM card as shown with PIN request disabled or read Security info how to enter it later in Configurator. Make sure that Micro-SIM card cut-off corner is pointing forward to slot.
- Connect battery as shown to device. Position the battery in place where it does not obstruct other components.
- Attach device cover back.
- Device is ready to be connected.
 |
Micro-SIM card insertion/removal must be performed when device is powered off – external voltage and internal battery disconnected. Otherwise Micro-SIM card might be damaged or device will not detect it. |
OBD II pinout
| Pin number | Pin name | Description |  |
|---|---|---|---|
| 1 | DIN1 | Ignition input. | |
| 2 | PWM_BUS+/VPW | ||
| 4 | GND (-) | Ground. | |
| 5 | GND (-) | Ground. | |
| 6 | CAN_H | CAN high. | |
| 7 | K-Line | ||
| 10 | PWM_BUS- | ||
| 14 | CAN_L | CAN low. | |
| 15 | L-Line | ||
| 16 | VCC (10 - 30)V DC (+) | Power supply (+10..+30 V DC). |
Template:FM3 First start config
Safety information
This message contains information on how to operate FMB001 safely. By following these requirements and recommendations, you will avoid dangerous situations. You must read these instructions carefully and follow them strictly before operating the device!
- The nominal voltage is +12 V DC while the allowed voltage range is +10..+30 V DC.
- To avoid mechanical damage, it is advised to transport the device in an impact-proof package.
- Before unmounting the device from the vehicle, ignition MUST be OFF.
Precautions
|
Do not disassemble the device. If the device is damaged, the power supply cables are not isolated or the isolation is damaged, DO NOT touch the device before unplugging the power supply. |
|
|
All wireless data transferring devices produce interference that may affect other devices which are placed nearby. |
|
Please consult representatives of your vehicle model regarding OBD II location on your vehicle. In case you are not sure about proper connection, please consult qualified personnel. |
|
The programming must be performed using a PC with autonomic power supply. |
|
The device is susceptible to water and humidity. |
|
Installation and/or handling during a lightning storm is prohibited. |
|
|
Teltonika is not responsible for any harm caused by wrong cables used for connection between PC and FMB001. |
|
|
WARNING! Do not use FMB001 device if it distracts driver or causes inconvenience due to OBD II placement. Device must not interfere with driver. |
