Upgrading CAN-CONTROL to CAN-CONTROl+Immobilizer

From Wiki Knowledge Base | Teltonika GPS
Revision as of 17:12, 14 January 2021 by Aurimas.vanagas (talk | contribs) (Created page with "Wiki. FAQ Upgrading CAN-CONTROL to CAN-CONTROl+Immobilizer Possible problems: 1. Doors Lock/Unlock is not working. 2. Doors Lock/Unlock works but engine blocking and unbloc...")

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)

Wiki. FAQ

Upgrading CAN-CONTROL to CAN-CONTROl+Immobilizer

Possible problems:

1. Doors Lock/Unlock is not working. 2. Doors Lock/Unlock works but engine blocking and unblock does not. Most of times response will be: CMD not supported. In some situations engine block will work but unblocking will not.

After installation is done and program number is set please do learning procedure.

1. send lvcansetprog 11120 (Or any other) 2. send lvcansetprog (one that is for your car model) 3. After you will receive response please do learning with key locking/unlocking 3 times. lock>unlock;lock>unlock;lock>unlock;

Now you can try commands to open and close doors. Now you can try commands to block and unblock engine.

All sms/gprs responces should inform you that command has been completed succesffully.

Note: If installing CAN-CONTROL adapter into different vehicle learning must be initiated. If adapter will be installed back on previous car model learning step must be repeated.

Retrieved from "https://wiki.teltonika-gps.com/index.php?title=Upgrading_CAN-CONTROL_to_CAN-CONTROl%2BImmobilizer&oldid=61938"