MTB100 Accessories
From Wiki Knowledge Base | Teltonika GPS
Revision as of 15:05, 2 May 2019 by Donatas.Andriulionis (talk | contribs)
Main Page > EOL Products > MTB100 > MTB100 Manual > MTB100 Accessories
Please order accessories separately as they are not included into device package. |
Accessory and its description | Accessory connection schematic |
---|---|
Fuel tank sensors | Fuel sensor connection to MTB100 |
A fuel tank level sensor that indicates the approximate fuel level on the driver's indicator panel exists in most cars. If the sensor returns an analog signal proportional to fuel level it can be connected to MTB100 Analog input. After connection to the tank fuel level sensor, a calibration is needed because most fuel tank sensors are not linear. Calibration is performed by measuring voltage values resulting from the volume of fuel in the tank. | |
Alarm buttons, door sensors etc. | Panic button connection to MTB100 |
Alarm buttons, door sensors, ignition, etc. have two output states: high or low. MTB100 Digital inputs are used to detect these states. | |
Relays | Inverting relay connection to MTB100 |
In cases when the sensor output signal is negative, an additional relay has to be installed to convert the negative signal to positive. | |
Immobilizer relay | Immobilizer relay connection to MTB100 output |
When connected as shown on the right hand side, MTB100 disables engine starter when output is ON. | |
Automotive relay | Automotive relay pinout |
An ordinary automotive relay is used to invert input signal or to immobilize engine starter. Note that relays can be 12 V or 24 V capable. |