How to install FMM640 to MB Actros

Revision as of 08:51, 6 December 2019 by Aurimas.vanagas (talk | contribs) (Created page with "800px|center ==Installation proccess== * Below is shown main installation location: 800px|center|Fuse panel cover...")

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)

Main Page > EOL Products > FMM640 > FMM640 Manual > How to install FMM640 to MB Actros

1 FMB + DAF.png

Installation proccess

Below is shown main installation location:

Carefully unscrew the fuse panel screws and fold the panel down.

Where to find main connector?

Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.

After installation and device configuration of FMM640 (CAN1 should be selected – FMS/TACHO), you can check if installation is properly made. Turn on ignition of vehicle and send SMS command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.

Retrieved from "https://wiki.teltonika-gps.com/index.php?title=How_to_install_FMM640_to_MB_Actros&oldid=50681"