Template:FMB Accelerometer Features settings

From Wiki Knowledge Base | Teltonika GPS

Excessive Idling

Fmb120 excessive idling.png

When vehicle stops for specific amount of time scenario is activated, record will be generated and digital output status will be changed to 1 (if configured). You can configure time it takes to turn on this scenario (Time to Stopped). Scenario is activated until vehicle starts moving and keeps moving (moving is detected only from accelerometer) for amount of time that is configured. You can configure time it takes to turn OFF this scenario (Time to Stopped).














Unplug Detection

Fmb120 unplug.png

Unplug Detection. Eventual event will be generated when FMB120 is unplugged from external power or plugged back again. User can select detection type: simple – used in cars, where power voltage is not dependant on ignition (recommended); advanced – used in cars, where power voltage is disconnected when ignition is switched off.









Bw nb.png In Unplug Detection and Towing Detection scenarios if Eventual Records is enabled Event will be generated (included into send records) only when scenario starts and finishes. If Eventual Records is disabled scenario status value is sent in each AVL record.

Towing Detection

Fmb120 towing.png

Towing detection feature helps to inform driver about car deporting. FMB1YX generates event when car is being towed or lifted, for example in case of vehicle evacuation.
















Crash Detection

Fmb120 crash.png

If Crash detection is enabled, it monitors acceleration on each axis, which helps to detect an accident.
If Crash trace is disabled crash detection event will be generated (included into send record) only when scenario starts and finishes.
If Crash trace is enabled FMB120 will collect acceleration data every 40 msec. Buffer is big enough to hold data for 5 seconds and on Crash Event detection, records will be generated from this buffer, following these conditions:

  • Every second Acceleration changed more then > 50mG Data will be collected and records generated 5 seconds after the event using the same conditions.
  • Every generated record will have accelerometer X Y Z values included.
  • Each record will have accurate timestamps in milliseconds.
Fmb120 crash trace.png
Retrieved from "https://wiki.teltonika-gps.com/index.php?title=Template:FMB_Accelerometer_Features_settings&oldid=7078"