FMB140 autoscan feature instructions

From Wiki Knowledge Base | Teltonika GPS
Revision as of 13:13, 20 March 2020 by Mocevicius.da (talk | contribs) (Created page with "Autoscan is a feature that automatically finds the best program number for your vehicle. Here is a quick guide on how to use the Autoscan feature. Step 1. Update FMB140 firmw...")

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)

Autoscan is a feature that automatically finds the best program number for your vehicle. Here is a quick guide on how to use the Autoscan feature.

Step 1. Update FMB140 firmware to FMB.Ver.03.25.15.Rev.141 or later

Step 2. Find the OBD-II port (diagnostic connector) in your vehicle. Connect the FMB140 CAN1L and CAN1H wires to OBD-II Connector PIN14 and PIN6 respectively.

IMG

Step 3. IMG

After the connection is done successfully, launch the configurator and navigate to CAN Adapter tab. Before clicking the Scan button, make sure that ignition is ON. FMB140 configured ignition source should be DIN1 or Power Voltage.

After pressing the scan button configurator will wait up to 60 seconds for device to send up to 9 program numbers. If timeout is reached configurator will display an error. If no CAN bus connection is detected, configurator will return an error after pressing scan button.

After a successful scan, you will receive a list of compatible program numbers. The first program number will be saved in device internal CAN chip and device configuration. You can try entering each of the scanned numbers into your configuration to see which parameters are available and which suggestion works best for your vehicle.

Retrieved from "https://wiki.teltonika-gps.com/index.php?title=FMB140_autoscan_feature_instructions&oldid=55573"