FMB122 Accessories
Revision as of 13:01, 23 May 2018 by Atabasnikov (talk | contribs) (Protected "FMB122 Accessories" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite)))
Main Page > Advanced Trackers > FMB122 > FMB122 Manual > FMB122 Accessories
![]() |
Please order accessories separately as they are not included into device package. |
Accessory and its description | Accessory connection schematic |
---|---|
Fuel tank sensors | Fuel sensor connection to FMB122 |
A fuel tank level sensor that indicates the approximate fuel level on the driver's indicator panel exists in most cars. If the sensor returns an analog signal proportional to fuel level it can be connected to FMB122 Analog input. After connection to the tank fuel level sensor, a calibration is needed because most fuel tank sensors are not linear. Calibration is performed by measuring voltage values resulting from the volume of fuel in the tank. | |
Alarm buttons, door sensors etc. | Panic button connection to FMB122 |
Alarm buttons, door sensors, ignition, etc. have two output states: high or low. FMB122 Digital inputs are used to detect these states. | |
Relays | Inverting relay connection to FMB122 |
In cases when the sensor output signal is negative, an additional relay has to be installed to convert the negative signal to positive. | |
Immobilizer relay | Immobilizer relay connection to FMB122 output |
When connected as shown on the right hand side, FMB122 disables engine starter when output is ON. | |
Automotive relay | Automotive relay pinout |
An ordinary automotive relay is used to invert input signal or to immobilize engine starter. Note that relays can be 12 V or 24 V capable. |
|
1-Wire devices | Digital thermometer DS1820 and TTJ100 connection to FMB122 |
One of the implemented features on FMB122 is 1-Wire® data protocol, which enables connection to devices such as thermometer (DS1820, DS18S20 and DS18B20) and I-Button DS1990A.
|
|
TTJ sensor pinout | |
I-Button DS1990A connection to FMB122 | |