RMA guidelines for FM devices
Revision as of 09:09, 5 July 2019 by Gediminas.suminas (talk | contribs) (Created page with "The table below contains information on which hardware related issues are covered by the warranty service and which issues are not: <table border=1; style="border-collapse: c...")
The table below contains information on which hardware related issues are covered by the warranty service and which issues are not:
Hardware issue | Does FM need to be sent to warranty? | Remote connection status |
---|---|---|
Device does not start. LED does not blink at all when device is powered up (10-30 V DC); If client ensures that device does have 10-30 V DC power supply and still does not start, such device should be sent to warranty. |
YES, if this issue is true | NOT REQUIRED |
Visible physical damage (FMXXXX damaged, GPS antenna damaged...): a. Visible physical damage on device case; |
YES, if at least one issue is true | NOT REQUIRED |
d. Visible physical damage on GPS antenna; |
NO, if at least one issue is true, offer to change an antenna | NOT REQUIRED |
VDigital input is not working: Connect DIN to powet supply „+“, and check if DIN status changes. If not – send to warranty |
YES, if this issue is true | NOT REQUIRED |
1-wire short circuit: a. Check 1-wire device type (maybe not supported device (ibutton, temp. sensor); |
YES, if all the points are false, but FM still does not send data | IS REQUIRED |
No GPS (GPS overcurrent, physical GPS antenna damage): a. Check terminal log, look for overcurrent messages; |
YES, if overcurrent message is still present after GPS antenna change | IS REQUIRED |
d. No overcurrent messages in log, but still no GPS FIX. If another FM device gets GPS FIX with the same antenna – send device to warranty. |
YES, if another FM device gets GPS FIX with the same antenna | IS REQUIRED |
Sim card failure. FM does not see SIM card (bended sim holder, 3G sim card, Modem version to old): a. Check SIM card itself, if there is no physical bending; |
YES, if none of the mentioned points helps | IS REQUIRED |
Firmware issue | Eligible for warranty? | Remote connection status |
---|---|---|
Device is in boot mode (status LED is blinking fast) – send instruction for device recovery. | NO | NOT REQUIRED |
Firmware blocked (security firmware) – check firmware description, if it is possible to reflash this firware to base FW. | YES | NOT REQUIRED |
Modem failure (Modem initializing, Modem Seems to be Dead) – make modem firmware update (using E2 flasher). | YES, if the solution does not help | IS REQUIRED |
Recommended course of action when firmware issues are encountered is to contact your sales representative if the device was purchased directly from Teltonika or contact Teltonika support if VIP HelpDesk access is provided to you. If you purchased the device elsewhere, contact the distributor that sold you the device.
Important: in any of the defined cases, please contact your sales representative before sending the device(s) to warranty.