EYE FUNCTIONALITIES NEW
Revision as of 17:09, 29 May 2023 by Aurimas.Alesius (talk | contribs)
Page Description
This page will describe EYE device functionalities, their flow and functionality supporting software versions.
Functionalities
Connecting to the device
Flow for firmware versions from 1.2.8.R.1+
| SW version requirements | EYE APP: 1.2.0-60+
Firmware: 1.2.8.R.1+ | ||||
|---|---|---|---|---|---|
| Step No. | 1 | 2 | 3 | 4 | |
| Short step desc. | Tap the selected device to connect to it | Wait for connection | Enter PIN | Successfully connected | |
| Successful attempt at functionality visual | |||||
| Step No. | 1 | 2 | 3 | 4 | 5 |
| Short step desc. | Tap the selected device to connect to it | Wait for device to connect | Enter PIN | You have connected to the device | Device is fully locked |
| Additional desc. | Tap the selected device to connect to it | Incorrect PIN has been entered 5 times | Device is locked for 5 min but will allow to connect with PIN again after timeout | Incorrect PIN has been entered 5 times | Device is locked, PIN will no longer be accepted until correct PUK code is entered |
| Failed attempt at functionality visual | |||||
PUK code unlock
| SW version requirements | EYE APP: 1.2.0-60+
Firmware: 1.2.8.R.1+ | ||||
|---|---|---|---|---|---|
| Step No. | 1 | 2 | 3 | ||
| Short step desc. | Tap the blocked device to connect to it | Enter PUK | Connected | ||
| Additional desc. | PIN automatically resets to default | ||||
| Successful attempt at functionality visual | |||||
| Step No. | 1 | 2 | |||
| Step desc. | Tap the selected device to connect to it | Enter PUK incorrectly | |||
| Additional desc. | Tap the selected device to connect to it | PUK is rejected and you can only go back or enter correct PUK | |||
| Failed attempt at functionality visual | |||||
Hibernate mode
Send to sleep
| SW version requirements | EYE APP: 1.2.0-60+
Firmware: 1.2.8.R.1+ | ||
|---|---|---|---|
| Step No. | 1 | 2 | 3 |
| Short step desc. | While connected and in overview tap "Send device to sleep" | Confirm your selection | Wait for EYE App to disconnect |
| Additional desc. | Device is no longer connectable or findable until wake up step is performed. | ||
| Successful attempt at functionality visual | |||
Wake up
| SW version requirements | Firmware: 1.2.8.R.1+ | ||||
|---|---|---|---|---|---|
| Step No. | 1-3 | 4 | |||
| Short step desc. | Attach magnet to sleeping device and wait for LED to blink. | Device starts broacasting | |||
| Additional desc. | Now device is discoverabled, scannable, connectable via BLE. | ||||
| Successful attempt at functionality visual |  |
||||