1,247
edits
Changes
Created page with "System settings have 7 configurable parameters: *Sleep settings, where user can turn GPS sleep/deep sleep on or off; *Analog Input Settings, where user can choose analog input..."
System settings have 7 configurable parameters:
*Sleep settings, where user can turn GPS sleep/deep sleep on or off;
*Analog Input Settings, where user can choose analog input range 10 V or 30 V,
depending on needed accuracy (lower range gives higher accuracy of
measurements), and input voltage;
*Object Motion Detection Settings, where user can configure 3 ways how {{{model|FM36YX}}}
will detect stopped movement, and change its working mode (for working modes,
read section 5.13)
*Static navigation settings, where user can turn static navigation on or off;
*Records Settings, where user can enable or disable records when GPS is not
available (no time synchronization);
*GNSS Settings, where user can choose satellite system and GNSS FIX Timeout Time
(if after timeout there will not be synchronized time, it will be synchronized via NTP
server).
*Ignition Source sets ignition triggered functionalities to be triggered by:
**Power Voltage (if voltage is between High Voltage Level and Low Voltage
Level the ignition is considered to be turned on);
**Digital Input (DIN1 ON – ignition on, DIN1 OFF – ignition off);
**Movement (if accelerometer/movement sensor detects movement then
ignition is on, if movement stops – ignition is off).
*Sleep settings, where user can turn GPS sleep/deep sleep on or off;
*Analog Input Settings, where user can choose analog input range 10 V or 30 V,
depending on needed accuracy (lower range gives higher accuracy of
measurements), and input voltage;
*Object Motion Detection Settings, where user can configure 3 ways how {{{model|FM36YX}}}
will detect stopped movement, and change its working mode (for working modes,
read section 5.13)
*Static navigation settings, where user can turn static navigation on or off;
*Records Settings, where user can enable or disable records when GPS is not
available (no time synchronization);
*GNSS Settings, where user can choose satellite system and GNSS FIX Timeout Time
(if after timeout there will not be synchronized time, it will be synchronized via NTP
server).
*Ignition Source sets ignition triggered functionalities to be triggered by:
**Power Voltage (if voltage is between High Voltage Level and Low Voltage
Level the ignition is considered to be turned on);
**Digital Input (DIN1 ON – ignition on, DIN1 OFF – ignition off);
**Movement (if accelerometer/movement sensor detects movement then
ignition is on, if movement stops – ignition is off).