Changes

no edit summary
Line 35: Line 35:  
'''''BLE Scan Duration''''' ''- 60 Seconds''
 
'''''BLE Scan Duration''''' ''- 60 Seconds''
   −
A Device first scans the sensors for the 60 seconds, after this time, the device will pack the remaining records to the AVL data package. Total sensors information update time will be 120 seconds.
+
Device will start the first scan after 120 seconds and will scan nearby BLE devices for 60 seconds to update configured sensor data. The sensor data will be updated every 120 seconds. Update Frequency is counted even while a scan is performed.
 +
 
 +
For example:
 +
Update frequency period passes. 120 seconds -> 0 seconds, a 60 second scan is initiated. Update Frequency countdown is restarted (countdown from configured value to 0) while the scan (according to the BLE Scan duration parameter) is performed.  
    
==Advanced Mode==
 
==Advanced Mode==
Line 134: Line 137:       −
Devices which are listed with the BT 4.0 supportive, have the extended List of the BLE Sensors which are available as the Preset settings and was fully tested from our end.
+
This list shows the supported BLE sensors and where their Presets can be found in the configurator to use those sensors with FMB devices. The prests and sensors have been fully tested by Teltonika and are confirmed to work properly.  
    
While following the steps showed in the images below, you can find the supported sensors in our Configurator.
 
While following the steps showed in the images below, you can find the supported sensors in our Configurator.
Line 152: Line 155:  
[[Image:Preset4.png|1200px|none]]
 
[[Image:Preset4.png|1200px|none]]
   −
The supportive sensors are listed below:
+
The supported sensors are listed below:
    
*BLE TPMS -Tire Pressure Monitoring System.
 
*BLE TPMS -Tire Pressure Monitoring System.