Changes

{| class="nd-othertables_2" style="border-style: solid; border-width: 0px"

{| class="nd-othertables_2" style="border-style: solid; border-width: 0px"

|+

|+

! style="text-align: center; vertical-align: top;" |Fuel sensor connection to {{{model|FMB1YX}}}

! style="text-align: center; vertical-align: top;" |Fuel sensor connection to {{{model|FMB1YX}}}

|-

|-

| style="text-align: left; vertical-align: top;" |A fuel tank level sensor which indicates the approximate fuel level on the driver's indicator panel exists in most cars. If the sensor returns analogue signal proportional to fuel level it can be connected to {{{model|FMB1YX}}} Analog input. After connection to the tank fuel level sensor a calibration is needed because most fuel tank sensors are not linear. Calibration is performed by measuring voltage values resulting from the volume of fuel in tank.

| style="text-align: left; vertical-align: top;" |A fuel tank level sensor that indicates the approximate fuel level on the driver's indicator panel exists in most cars. If the sensor returns an analog signal proportional to fuel level it can be connected to {{{model|FMB1YX}}} Analog input. After connection to the tank fuel level sensor, a calibration is needed because most fuel tank sensors are not linear. Calibration is performed by measuring voltage values resulting from the volume of fuel in the tank.

| style="text-align: left; vertical-align: top;" |[[Image:Sch_fmb1yx_lls.png|250px|center]]

| style="text-align: left; vertical-align: top;" |[[Image:Sch_fmb1yx_lls.png|250px|center]]

|-

|-

! style="text-align: center; vertical-align: top;" |Inverting relay connection to {{{model|FMB1YX}}}

! style="text-align: center; vertical-align: top;" |Inverting relay connection to {{{model|FMB1YX}}}

|-

|-

| style="text-align: left; vertical-align: top;" |In cases when sensor output signal is negative, an additional relay has to be installed to convert negative signal to positive.

| style="text-align: left; vertical-align: top;" |In cases when the sensor output signal is negative, an additional relay has to be installed to convert the negative signal to positive.

| style="text-align: left; vertical-align: top;" |[[Image:Sch_fmb1yx_inv_relay.png|400px|center]]

| style="text-align: left; vertical-align: top;" |[[Image:Sch_fmb1yx_inv_relay.png|400px|center]]

|-

|-