1,663
edits
Changes
→Teltonika configurator
If you have firmware / configurator which does not support EYE sensor tab in Bluetooth 4.0 section, then you can still use Avanced BLE configuration to connect with EYE Sensors.
If you have firmware / configurator which does not support EYE sensor tab in Bluetooth 4.0 section, then you can still use Avanced BLE configuration to connect with EYE Sensors.
To configure BTSMP1 you can:
To configure FM with BTSMP1 EYE Sensor:
0) Make sure that name of the sensor is default length (10 symbols)1) Load EYE Sensor preset in your configurator according to the set Eye Sensor protocol set in EYE App -> Basic Settings -> Packet settings.
2) Configure MAC address of the sensor
If you do not have preset you can download them from below table:
{| class="wikitable"
{| class="wikitable"
|+
|+
|-
|-
|EYE APP Setting:
|[[File:Eye Sensors.png|left|frameless]]
|[[File:Eye Sensors.png|left|frameless]]
|
|
[[File:Eddystone and EYE Sensors.png|frameless]]
[[File:Eddystone and EYE Sensors.png|frameless]]
|-
|-
|Preset download [[File:Download_zip.png|x30px|link=Special:Redirect/file/EYE_Sensors.zip]]
|Preset you should use:
|Preset download [[File:Download_zip.png|x30px|link=Special:Redirect/file/EYE_iBeacon.zip]]
|EYE Sensors
|Preset download [[File:Download_zip.png|x30px|link=Special:Redirect/file/EYE_Eddystone.zip]]
|EYE iBeacon
|EYE Eddystone
|-
|Preset download link:
|[[File:Download_zip.png|x30px|link=Special:Redirect/file/EYE_Sensors.zip]]
|[[File:Download_zip.png|x30px|link=Special:Redirect/file/EYE_iBeacon.zip]]
|[[File:Download_zip.png|x30px|link=Special:Redirect/file/EYE_Eddystone.zip]]
|-
|-
| colspan="3" |Altenatively you can manually add a preset: [[How_to_add_a_BLE_preset_to_the_configurator|Instructions]]
| colspan="4" |Instructions how you can manually add a preset: [[How_to_add_a_BLE_preset_to_the_configurator|link]]
|}
|}