Line 46: |
Line 46: |
| | | |
| ==SIMPLE-CAN - contactless CAN-BUS reader== | | ==SIMPLE-CAN - contactless CAN-BUS reader== |
| + | |
| + | [[Image:Fmb120_simplecan.png|300px|right]] |
| + | SIMPLE-CAN is contactless adapter used to read vehicle CAN data with LV-CAN200, ALL-CAN300. If LV-CAN200 or ALL-CAN300 connection requires two CAN lines to get all data, then you need two SIMPLE-CAN readers. |
| + | |
| + | <font size="+1">Technical details</font> |
| + | * Power supply voltage 9-63 V. |
| + | * Power supply current standby 1.6 mA, active 8.3 mA @ 12 V; standby 0.91 mA, active 4.3 mA @ 24 V. |
| + | * CAN-BUS speeds from 33,33 to 500 kb/s. |
| + | * Automatically sets CAN Low, CAN High polarity. |
| + | * Automatically adjusts signal level and speed.<br/><br/> |
| + | |
| + | SIMPLE-CAN works in the '''listening mode only''', so not all the data available on the CAN-BUS may be received using this solution. '''The device automatically sets CAN L/H polarity''', but the calibration has to be always executed during installation process. Connection of previously calibrated unit to another car needs new calibration because the reader '''automatically adjusts signal level and speed''' to different CAN-BUSes. The device also '''automatically adapts''' to the found '''noise level'''. |
| + | |
| + | [[Image:Fmb120_simplecan_pinout.png|800px|center]] |
| + | |
| + | After power supply connecting, LED shines continuously. It means that device waits for calibration. '''Calibration process''' has to be carried out when CAN-BUS twisted pair is tightened on SIMPLE-CAN and when the ignition is ON. Please press the switch shortly and wait for the LED to start blinking every 1 second. Automatic calibration process takes up to 10 seconds depending on the vehicle's model. Correct calibration process is confirmed by LED's every 2 seconds blink (when the CAN-BUS is active). When the CAN-BUS enters sleep mode, SIMPLE-CAN device does it also and takes 1,6mA/12V. In the sleep mode LED does not shine. If after calibration process LED shines continuously, it means that device is not calibrated yet, CAN-BUS transmission has failed or ignition during calibration was not ON. |
| + | |
| ==Connecting FMB120 Can adapters ALL-CAN300 and LV-CAN200== | | ==Connecting FMB120 Can adapters ALL-CAN300 and LV-CAN200== |
| ==FMB120 ALL-CAN300 and LV-CAN200 parameters configuration== | | ==FMB120 ALL-CAN300 and LV-CAN200 parameters configuration== |
| ==Send data with 0, if ignition is off== | | ==Send data with 0, if ignition is off== |
| ==LV -CAN200/ALLAN300 Important Information== | | ==LV -CAN200/ALLAN300 Important Information== |