1,645
edits
Changes
no edit summary
*'''''NOTE:''''' ''This is a base setup for the device to work properly. Other device configuration is made according to your needs.
*'''''NOTE:''''' ''This is a base setup for the device to work properly. Other device configuration is made according to your needs.
''
''
===Camera Scenario Mode===
The options On Ignition and Always determine the working mode.
'''On Ignition''' means the camera scenarios will operate the way it was up to '''03.27.03.Rev.105''', that is it will work only when the ignition is detected.
'''Always''' mode means the camera scenarios will work all the time, including whenever the device is in sleep mode (excepting Ultra sleep mode during which scenario is disabled). During sleep footage requests (if the network is available), periodic image sending and triggers work as well.
'''Warning:''' using Always mode, depending on the configuration, the device might wake up from sleep very frequently. That has to be taken into consideration when configuring the scenarios.
===Periodic image sending scenario===
Periodic image sending triggers photo capture from a front camera, whenever the timeout is reached (sending interval parameter).
'''Update: Since 03.27.03.Rev.04 firmware''', Periodic Image Sending Enable/Disable switch was replaced by a camera selection:
* Both cameras deselected – periodic image sending is disabled (value 0)
* Front camera selected – front camera’s pictures will be sent periodically (value 1)
* Rear camera selected – rear camera’s pictures will be sent periodically (value 2)
* Both cameras selected – both cameras’ pictures will be sent periodically (value 3)
If the camera has not finished uploading pictures to the server, then the photo capture is skipped.
==Camera RTC synchronization==
Camera RTC synchronization is done anytime the device itself is synchronized (via NTP, NITZ or GNSS).
After 03.27.07.Rev:364 firmware for FMX125 we added a feature to set camera time, same as device selecting time.
[[File:Zone.jpg|alt=|frameless]]
'''NOTE''':
That after changes of the time it can be that you can receive files which the old-time or just do not have any video/photo on this periodical time then you change time, but then it will be back to normal work.
Time zone changes the inside clock of the camera, not only the OSD displayed time but all recordings will be done according to that.
For example, if you request a video from, say, 9:00 AM GMT+0, and the camera time is GMT+0 (matches our device's time), it is all fine. But if you were to configure time zone later to, for instance, GMT+10, the camera time will be set according to that time zone (time forwarded by 10 hours in this case). Which means that time gets forwarded with no real continuation as the camera does not understand the concept of time zones, it just uses time that we set. For continuation reasons in our device, we continue using GMT+0 in the camreq and then compensate with time zone if needed. The result of that, if we send the same request command as before (when requesting 9:00 AM video) with time zone GMT+10 set, the camera will receive video request for 7 PM (19:00) and the videos were not recorded at that time which will result in "file doesn't exist".
<br>