Changes

==='''Step 2.'''  FMx640 Configuration:===

==='''Step 2.'''  FMx640 Configuration:===

The FMx configurator you have to set parameters for COM1 or COM2 (depends on which COM port you are using) in global parameters window. You have to modify the server sittings to you PC IP and your TCP port.

The FMx configurator you have to set parameters for COM1 or COM2 (depends on which COM port you are using) in global parameters window. You have to modify the server sittings to you PC IP and your TCP port.  

   [[File:GPRS sittings .jpg|alt=|center|thumb|1162x1162px|Configuring server sitting]]

   [[File:GPRS sittings .jpg|alt=|center|thumb|1164x1164px|Configuring server sitting]]

[[File:RS232 Sittings.jpg|alt=|center|frameless|1167x1167px|Configure RS232 Sittings]]

[[File:RS232 Sittings.jpg|alt=|center|frameless|1167x1167px|Configure RS232 Sittings]]

Here you have to send acknowledgement after receiving the IMEI from the device. then You have to send 01 as a server response.

Here you have to send acknowledgement after receiving the IMEI from the device. then You have to send 01 as a server response.

[[File:Sending messages with Hercules.jpg|center|thumb|555x555px|Sending messages with Hercules|alt=]]

[[File:Hercules .jpg|alt=|none|thumb|666x666px|Sending messages with Hercules]]

 

You have to choose TCP Server section from the upper menu. In the marked fields.

You have to choose TCP Server section from the upper menu. In the marked fields.

In this step we need to use the terminal log.  When you want to send a message from FMx 640 to the server, write it in Terminal but change your com port and select port which is assigned for COM1/COM2.

In this step we need to use the terminal log.  When you want to send a message from FMx 640 to the server, write it in Terminal but change your com port and select port which is assigned for COM1/COM2.

 

[[File:Terminal.jpg|alt=|none|thumb|1002x1002px|Terminal Log Sending Text]]

[[File:Terminal Log Sending Text.png|center|thumb|600x600px|Terminal Log Sending Text|alt=]]

After doing the mentioned configuration you can type your message in the marked field, check +CR and press Send button. If sent successfully, you will see it in Hercules Received data field.

After doing the mentioned configuration you can type your message in the marked field, check +CR and press Send button. If sent successfully, you will see it in Hercules Received data field.

[[File:Receiving Text From The Terminal to Server Hercules.png|center|thumb|600x600px|Receiving Text from The Terminal to Server Hercules|alt=]]

[[File:Final MSG.jpg|alt=|none|thumb|737x737px|Receiving Text from The Terminal to Server Hercules]]