260
edits
Changes
new gif, that match the dashcam configurator
[[Image:Data_protocol.gif|300px]]
[[Image:Data_protocol.gif|300px]]
*In '''RS232\RS485''' settings change '''Mode''' to ''RS232'' and in '''RS232 Mode''' select ''DashCam''
[[File:DashCam232.gif|500px]]
*Make sure to change '''I/O''' Camera state '''Priorities''' to ''Low''
*Make sure to change '''I/O''' Camera state '''Priorities''' to ''Low''
'''
'''
[[File:Io.gif|500px]]
[[File:DashCamIo.gif|500px]]
'''
'''
*'''Do not forget''' to configure ''DashCam'' server information. In '''RS232\RS485''' fill in '''DashCam Server Settings''' with ''Domain'' and ''Port'' entries.
*'''Do not forget''' to configure ''DashCam'' server information. In '''RS232\RS485''' fill in '''DashCam Server Settings''' with ''Domain'' and ''Port'' entries.
[[File:Dualcamserver.png|600px]]
[[File:Dashcamserver.png|600px]]
*'''''NOTE:''''' ''This is a base setup for the device to work properly. Other device configuration is made according to your needs.
*'''''NOTE:''''' ''This is a base setup for the device to work properly. Other device configuration is made according to your needs.
''
''
*'''''NOTE:''''' ''There are different settings for picture quality and compression, these settings will affect picture/video sizes and upload speeds. For more information about transfer sizes and timings, please visit our [[DashCam_Camera_Manual#DashCam_data_transfer_timing | DashCam Data Trasnfer Timing]] section
*'''''NOTE:''''' ''There are different settings for picture quality and compression, these settings will affect picture/video sizes and upload speeds. For more information about transfer sizes and timings, please visit our [[DashCam_Camera_Manual#DashCam_data_transfer_timing | DashCam Data Transfer Timing]] section
''
''
'''On Ignition''' means the camera scenarios will operate the way it was up to '''03.27.03.Rev.105''', that is it will work only when the ignition is detected.
'''On Ignition''' means the camera scenarios will operate the way it was up to '''03.27.03.Rev.105''', that is it will work only when the ignition is detected.
'''Always''' mode means the camera scenarios will work all the time, including whenever the device is in sleep mode (excepting Ultra sleep mode during which scenario is disabled). During sleep footage requests (if the network is available), periodic image sending and triggers work as well.
'''Always''' mode means the camera scenarios will work all the time, including whenever the device is in sleep mode (except Ultra sleep mode during which the scenario is disabled). During sleep footage requests (if the network is available), periodic image sending and triggers work as well.
'''Warning:''' using Always mode, depending on the configuration, the device might wake up from sleep very frequently. That has to be taken into consideration when configuring the scenarios.
'''Warning:''' using Always mode, depending on the configuration, the device might wake up from sleep very frequently. That has to be taken into consideration when configuring the scenarios.