312
edits
Changes
no edit summary
[[File:ADAS_w_DOUT6.jpg]]
[[File:ADAS_w_DOUT6.jpg]]
'''Two cameras FMC650 Installation with Relay'''
. If you need to receive additional data from the Two cameras or one of them when the ignition is off, you can also connect the camera to a power source using the relay, to control the power supply by turning on/off the camera. To find information on how to configure DOUT, please visit [[FMB setdigout|FMB DOUT]].
[[File:2 cameras dout.JPG]]
'''Two cameras FMC650 Installation with Ignition Source.''' To connect the two cameras to the FMC650 device, you have to make sure to connect 4 PIN's of the camera to the PIN's of your device correctly.
NOTE: Two cameras must be connected to the ignition source or another source, where then you turn off ignition camera will turn off in another case camera will drain the battery if you connect directly.
[[File:688548 DualCam and DSM with FMC650.jpg]]
{| class="wikitable"
{| class="wikitable"
* Enable Transmit data RS-232 feature
* Enable Transmit data RS-232 feature
(Converter mode should be selected to work with FMx125).
(115200 mode should be selected to work with FMx125).
It allows ADAS event data transmission to integrated device.
It allows ADAS event data transmission to integrated device.
* Enable Vibration setting for LDW, FCW, PCW (On / Off / Both).
* Enable Vibration setting for LDW, FCW, PCW (On / Off / Both).
You can check the connection with the button.
You can check the connection with the button.
|[[File:Mdconfi6.1.png|center|frameless]]
|[[File:Image (3).png|center|frameless]]
|-
|-
| colspan="2" |'''Miscellaneous Settings:'''
| colspan="2" |'''Miscellaneous Settings:'''