Wiki Knowledge Base | Teltonika GPS

Changes

DualCam Configuration (view source)

Revision as of 19:32, 25 October 2023

140 bytes removed ,  19:32, 25 October 2023
no edit summary
Line 26: Line 26:     
*In ''RS232 \ RS485 settings tab'', make sure to choose '''DualCam''' to '''COM1/COM2 settings''', and set the required '''baudrate'''.
 
*In ''RS232 \ RS485 settings tab'', make sure to choose '''DualCam''' to '''COM1/COM2 settings''', and set the required '''baudrate'''.
 +
As soon as '''DualCam''' is selected, ''COM1 Camera'' and ''Camera I/O settings'' tabs will appear in the configurator menu.
   −
[[Image:Dualcam rs232.png|600px]]
+
[[Image:DualCam config.gif|600px]]
−
 
  −
*Make sure to change '''I/O''' Camera state '''Priorities''' to ''Low''
  −
'''
  −
[[File:Io.gif|500px]]
  −
'''
  −
 
  −
*As soon as '''DualCam''' is selected, ''COM1 Camera'' and ''Camera I/O settings'' tabs will appear in the configurator menu.
  −
 
  −
[[Image:Com1 cameraio.png|600px]]
      
*In appeared ''COM1 Camera tab'', make sure to '''configure everything by your needs''', and do not forget to complete the '''"Domain"''' and '''"Port"''' settings in ''"DualCam" Scenario Settings''
 
*In appeared ''COM1 Camera tab'', make sure to '''configure everything by your needs''', and do not forget to complete the '''"Domain"''' and '''"Port"''' settings in ''"DualCam" Scenario Settings''
−
  −
       
Retrieved from "https://wiki.teltonika-gps.com/view/Special:MobileDiff/90164"