Changes

*In ''RS232 \ RS485 settings tab'', make sure to enable '''Camera interface''' by "Enable", and select '''DSM''' in the Mode drop-down menu, afterwards '''DSM COM1''' and '''Camera I/O''' should appear in the tab list.

*In ''RS232 \ RS485 settings tab'', make sure to enable '''Camera interface''' by "Enable", and select '''DSM''' in the Mode drop-down menu, afterwards '''DSM COM1''' and '''Camera I/O''' should appear in the tab list.

[[Image:DSM config.gif|600px]]

[[Image:ADAS COM1.gif|600px]]

*Make sure to change '''Camera I/O''' camera state '''Priorities''' to ''Low''

*Make sure to change '''Camera I/O''' camera state '''Priorities''' to ''Low''