54
edits
Changes
no edit summary
{|
{|
{{#if:{{{TFT_system_settings|}}}
{{#if:{{{TFT_show|}}}
|
|
|===PDOP filter===
|===PDOP filter===
{|
{|
{{#if:{{{TFT_system_settings|}}}
{{#if:{{{TFT_show|}}}
|
|
|===Input/Output Mode===
|===Input/Output Mode===
}}
}}
|}
|}
{|
{|
{|
{|
{{#if:{{{TFT_system_settings|}}}
{{#if:{{{TFT_show|}}}
|
|
|===Analog Input Value Range===
|===Analog Input Value Range===
{|
{|
{{#if:{{{TFT_DOUT_Overcurrent_protection|}}}
{{#if:{{{TFT_show|}}}
|
|
|===DOUT Overcurrent protection===
|===DOUT Overcurrent protection===
Also, <b>GSM Cell ID</b> and <b>Active GSM Operator</b> should have at least Low priority in I/O settings.<br>[[Image:LBS IO.jpg|left]]
Also, <b>GSM Cell ID</b> and <b>Active GSM Operator</b> should have at least Low priority in I/O settings.<br>[[Image:LBS IO.jpg|left]]
<br><br><br>
<br><br><br><br>
}}
}}
|}
|}
{|
{|
{|
{|
{{#if:{{{TFT_show|}}}
{{#if:{{{TFT_Static_Navigation|}}}
|
|
|==Static Navigation Settings==
|==Static Navigation Settings==
{|
{|
{{#if:{{{TFT_Accelerometer_delay|}}}
{{#if:{{{TFT_Accelerometer_Delay|}}}
|
|
|==Accelerometer Delay Settings==
|==Accelerometer Delay Settings==
</tr>
</tr>
</table>
</table>
}}
}}
|}
|}
{|
{|
{{#if:{{{TFT_accelerometer_calibration|}}}
{{#if:{{{GH_TMT_section|}}}
|
|==Movement Settings==
[[Image:Accelerometer settings.png|right]]
Here the user can set the movement start/stop delays. <br/>
''For example'', if the '''''Movement Start Delay''''' is set to 1s and '''''Movement Stop Delay''''' to 60s, the movement will be detected after 1s of moving and defined as stopped after 60s when device stopped moving. Accelerometer Sensitivity in Sleep parameter defines how much movement device needs to experience to exit sleep mode. The lower the sensitivity - the more movement is required.
*<code>Minimal</code> – approximately 40% higher movement threshold comparing to Normal
*<code>Reduced</code> – approximately 20% higher movement threshold comparing to Normal
*<code>Normal</code> – recommended value for most users
*<code>Increased</code> – approximately 20% lower movement threshold comparing to Normal
*<code>Maximum</code> – approximately 40% lower movement threshold comparing to Normal
Changing Accelerometer Sensitivity in Sleep parameter might result in fake movement record or skipped movement events! Only change that if you experience problems with movement detection!
}}
|}
{|
{{#if:{{{TFT_show|}}}
|
|
|==Accelerometer Auto Calibration==
|==Accelerometer Auto Calibration==
{|
{|
{{#if:{{{TFT_Mounting_Guidelines|}}}
{{#if:{{{TFT_show|}}}
|
|
|=== Mounting Guidelines ===
|=== Mounting Guidelines ===
{|
{|
{{#if:{{{TFT_system_settings|}}}
{{#if:{{{TFT_show|}}}
|
|
|==Timestamp Backup==
|==Timestamp Backup==