Template:FTX First Start
Revision as of 09:48, 14 February 2025 by Irmantas.K (talk | contribs) (Created page with "<b> {{#switch: {{{model|FTC881}}} | FTC881 = Small and smart waterproof tracker | FTC921 = Small and smart tracker | FTC961 = Small and smart waterproof tracker | FTC305 = Small tracker for e-bikes, e-scooters and e-forklifts with CAN interface, high gain GNSS/GSM antennas, Bluetooth® wireless technology, high capacity internal Li-ion battery and 10-97 V power supply range | #default = Small and smart tracker }} </b> [[Image:{{{model|}}}-datasheet.png|400px|right]] <b...")
Small and smart waterproof tracker
KNOW YOUR DEVICE
SET UP YOUR DEVICE
- Device is delivered partly closed. Gently remove FTC881 cover.
- Insert Nano-SIM card as shown. Make sure that Nano-SIM card cut-off corner is pointing towards SIM slot.
- Battery is already connected, so after configuring device fully close casing.
- Device is ready to be mounted.
 |
Nano-SIM card insertion/removal must be performed when device is powered off – external voltage and internal battery disconnected. Otherwise Nano-SIM card might be damaged or device will not detect it. |
HOW TO REMOVE COVER
{
PC CONNECTION (WINDOWS)
- Power-up {{{model}}} with DC voltage (10-90V) power supply using power wires. LEDs should start blinking, see "LED BEHAVIOUR DESCRIPTION".
- Connect device to computer using USB Type-C cable and install USB driver, see "HOW TO INSTALL USB DRIVERS (WINDOWS)".
LED BEHAVIOUR DESCRIPTION
This section is an explanation of LED indications on an {{{model}}} device.
NAVIGATION LED INDICATIONS
| Behaviour | Meaning |
|---|---|
| Permanently switched on | GNSS signal is not received |
| Blinking every second | Normal mode, GNSS is working |
| Off | GNSS is turned off because: Device is not working or Device is in sleep mode |
| Blinking fast constantly | Device firmware is being flashed |
STATUS LED INDICATIONS
| Behaviour | Meaning |
|---|---|
| Blinking every second | Normal mode |
| Blinking every two seconds | Sleep mode |
| Blinking fast for a short time | Modem activity |
| Off | Device is not working or Device is in boot mode |
HOW TO INSTALL USB DRIVERS (WINDOWS)
- Please download COM port drivers from here.
- Extract and run TeltonikaCOMDriver.exe.
- Click Next in driver installation window.
- In the following window click Install button.
- Setup will continue installing the driver and eventually the confirmation window will appear. Click Finish to complete the setup.
CONFIGURATION (WINDOWS)
At first {{{model}}} device will have default factory settings set. These settings should be changed according to the user's needs. Main configuration can be performed via Teltonika Configurator tool (TCT).
PINOUT
{
MOUNTING RECOMMENDATIONS
DEVICE FASTENING
- Locate the battery in your vehicle. If present remove the battery cover to access the battery.
- There is a double sided tape on the back of the device, use it to attach the device on the battery, so that the GNSS antenna and LEDs indicators are facing up.
CONNECTING POWER SOURCE
- Device power wire is designed to be directly connected to the positive terminal fastener of the vehicle battery.
CONNECTING GROUND WIRE
- Device ground wire is designed to be directly connected to the negative terminal fastener of the vehicle battery.
[[Category:{{{model}}}]]