Template:FM36 System Settings
From Wiki Knowledge Base | Teltonika GPS
Revision as of 12:14, 31 May 2018 by Simkunas.ma (talk | contribs) (Created page with "System settings have 7 configurable parameters: *Sleep settings, where user can turn GPS sleep/deep sleep on or off; *Analog Input Settings, where user can choose analog input...")
System settings have 7 configurable parameters:
- Sleep settings, where user can turn GPS sleep/deep sleep on or off;
- Analog Input Settings, where user can choose analog input range 10 V or 30 V,
depending on needed accuracy (lower range gives higher accuracy of measurements), and input voltage;
- Object Motion Detection Settings, where user can configure 3 ways how FM36YX
will detect stopped movement, and change its working mode (for working modes, read section 5.13)
- Static navigation settings, where user can turn static navigation on or off;
- Records Settings, where user can enable or disable records when GPS is not
available (no time synchronization);
- GNSS Settings, where user can choose satellite system and GNSS FIX Timeout Time
(if after timeout there will not be synchronized time, it will be synchronized via NTP server).
- Ignition Source sets ignition triggered functionalities to be triggered by:
- Power Voltage (if voltage is between High Voltage Level and Low Voltage
Level the ignition is considered to be turned on);
- Digital Input (DIN1 ON – ignition on, DIN1 OFF – ignition off);
- Movement (if accelerometer/movement sensor detects movement then
ignition is on, if movement stops – ignition is off).
