FM36M1 Accessories

Please order accessories separately as they are not included into device package.

Accessory and its description	Accessory connection schematic
Fuel tank sensors	Fuel sensor connection to FM36M1
A fuel tank level sensor which indicates the approximate fuel level on the driver's indicator panel exists in most cars. If the sensor returns analogue signal proportional to fuel level it can be connected to FM36M1 Analog input. After connection to the tank fuel level sensor a calibration is needed because most fuel tank sensors are not linear. Calibration is performed by measuring voltage values resulting from the volume of fuel in tank.
Alarm buttons, door sensors etc.	Panic button connection to FM36M1
Alarm buttons, door sensors, ignition, etc. have two output states: high or low. FM36M1 Digital inputs are used to detect these states.
Relays	Inverting relay connection to FM36M1
In cases when sensor output signal is negative, an additional relay has to be installed to convert negative signal to positive.
Immobilizer relay	Immobilizer relay connection to FM36M1 output
When connected as shown on the right hand side, FM36M1 disables engine starter when output is ON.
Automotive relay	Automotive relay pinout
An ordinary automotive relay is used to invert input signal or to immobilize engine starter. Note that relays can be 12 V or 24 V capable.
1-Wire devices	Digital thermometer DS1820 and TTJ100 connection to FM36M1
One of the implemented features on FM36M1 is 1-Wire® data protocol, which enables connection to devices such as thermometer (DS1820, DS18S20 and DS18B20) and I-Button DS1990A.
	TTJ sensor pinout
	I-Button DS1990A connection to FM36M1