FMB140 Accessories

From Wiki Knowledge Base | Teltonika GPS
Main Page > CAN Trackers & Adapters > FMB140 > FMB140 Manual > FMB140 Accessories
Bw nb.png Please order accessories separately as they are not included into device package.


Accessory and its description Accessory connection schematic
Fuel tank sensors Fuel sensor connection to FMB140
A fuel tank level sensor which indicates the approximate fuel level on the driver's indicator panel exists in most cars. If the sensor returns analogue signal proportional to fuel level it can be connected to FMB140 Analog input. After connection to the tank fuel level sensor a calibration is needed because most fuel tank sensors are not linear. Calibration is performed by measuring voltage values resulting from the volume of fuel in tank.
Sch fmb1yx lls.png
Alarm buttons, door sensors etc. Panic button connection to FMB140
Alarm buttons, door sensors, ignition, etc. have two output states: high or low. FMB140 Digital inputs are used to detect these states.
Sch fmb1yx panic.png
Relays Inverting relay connection to FMB140
In cases when sensor output signal is negative, an additional relay has to be installed to convert negative signal to positive.
Sch fmb1yx inv relay.png
Immobilizer relay Immobilizer relay connection to FMB140 output
When connected as shown on the right hand side, FMB140 disables engine starter when output is ON.
Sch fmb1yx imb relay.png
Automotive relay Automotive relay pinout
An ordinary automotive relay is used to invert input signal or to immobilize engine starter. Note that relays can be 12 V or 24 V capable.
Pic relay.png
Sch ord relay.png
1-Wire devices I-Button DS1990A connection to FMB140
One of the implemented features on FMB140 is 1-Wire® data protocol, which enables the use of I-Button DS1990A.

The FMB140 does not have a 1-Wire Power connection, so most other 1-Wire devices compatible with FMB1YX family are uncompatible with the FMB140 (DS1820, DS18S20 and DS18B20).

Sch fmb1yx ibutton.png