MSP500 LED status
Revision as of 04:49, 26 March 2020 by Tomas.kriauciunas (talk | contribs) (Created page with "{{ Template:FMB1 LED status |model=MSP500 }} Category:MSP500 Manual")
Main Page > EOL Products > MSP500 > MSP500 Manual > MSP500 LED status
This section is an explanation of LED indications on an MSP500 device.
| Behaviour | Meaning |
|---|---|
| Permanently switched on | GNSS signal is not received |
| Blinking every second | Normal mode, GNSS is working |
| Off | GNSS is turned off because: Device is not working or Device is in sleep mode |
| Blinking fast constantly | Device firmware is being flashed |
Status LED Indications
| Behaviour | Meaning |
|---|---|
| Blinking every second | Normal mode |
| Blinking every two seconds | Sleep mode |
| Blinking fast for a short time | Modem activity |
| Off | Device is not working or Device is in boot mode |
CAN Status LED indications
| Behaviour | Meaning |
|---|---|
| Blinking fast constantly | Reading CAN data from vehicle |
| Permanently switched on | CAN unit unresponsive |
| Off | Wrong program number or wrong wire connection or CAN processor is in sleep mode = CAN data not received |