Iridium Edge First Start

First Start

Wiring diagram

FMX125 device connection to Irridium edge via FMX125 devices.

FMX640 device connection to Irridium edge via FMX640 devices.

Installation

Iridium Edge Quick Installation Guide document will show how to install Iridium Edge into the vehicle and prepare the device for configuration with our FMX640 and FMX125 family devices.

Please note: it is essential to follow all the instructions for effective installation, if any further questions arise, please contact your sales representative for more information.

Key Features

• Hardware-Ready Device for Simple, Low Risk Integration
• Satellite Add-On for Truly Global Coverage
• Robust Power Supply for Industrial Installations
• Certified in Key Geographic Markets
• 180° Line of Sight for Compromised, Partially Blocked Locations

Network characteristics

• Frequency: 1616 – 1626.5 MHz
• Message Size: 14 Bytes (Receive), 14 Bytes (Transmit)
• SBD Transceiver: Iridium 9602N
• Antenna: Integrated Iridium® Certified Antenna

Environmental characteristics

• Operating/Storage Temperature Range: -40C to 85C
• Vibration: SAE J1455, Section 4.10

Mechanical characteristics

• Dimensions (LxWxH): 130 x 80 x 30mm
• Ingress Protection: IP 67
• Side & Bottom Cable Exits
• Connector: M12-8 pin male, terminated on 20cm
• Pigtail Cable
• Installation Options: Pole, Screw, Tape

Electrical characteristics

• Power Supply: ( 9-32V), SAE J1455 Load Dump Protected
• Maximum Power: 1.6W (Peak for Short Transmit Burst)
• Low Power Modes: < 200uA
• Reverse Polarity Protection

Interface characteristics

• RS232 AT Command Interface
• On / Off Control Lines