TMT250 User interface

From Wiki Knowledge Base | Teltonika GPS
Revision as of 12:29, 13 April 2023 by Martyna.D (talk | contribs) (Protected "TMT250 User interface" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite)))

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)
Main Page > Autonomous Trackers > TMT250 > TMT250 Configuration > TMT250 User interface


Indication is configurable in User Interface tab of configurator or via SMS/GPRS parameter ID. Each 100 ms device checks if any indication is enabled in response to triggered scenarios. If two scenarios need to indicate on the same indication source (LED or Vibration) then the active indicating scenario needs to be finished first (with exception of Alarm and Device Off scenarios, which can override the control of indication sources). Period setting is indicative of Periodic scenarios and if Period is set to 0 the indication will take place immediately. When indication is periodic and On parameter value is set to 0, the indication source will stay on until the scenario is finished. Triggered scenarios will turn on LED and/or Vibration for a configured On duration and then keep them off for a configured Off period of time. In case the configured Repeat value is higher than 0 the device continues a periodic on/off cycle. Enable In Sleep parameter will let the indication work while device is sleeping.

GSM Indications

TMT250 GSM Indication.PNG

Name Meaning
GSM Error SIM is not inserted, failed to connect to GSM operator or GSM signal is being jammed
GSM Signal Established Device successfully registered to GSM network
SMS Send/Receive SMS is received or sent
Incoming Call Device notices incoming call
Remote Connection Device establishes connection with the server

GNSS Indications

TMT250 GNSS Indication.PNG

Name Meaning
No GPS Fix Device searches for valid GPS fix
GPS Fix Device has valid GPS fix

Event Indications

TMT250 Event Indication.PNG

Name Meaning
Event Eventual record is saved
Panic Event Panic record is saved
Device Off Device is turning off
Device On Device is turning on
Pre Alarm Indication when Man-down or No Movement event functionality starts counting timeout till event
I Am Alive Periodical indication that device is on
Sleep Mode Device is in sleep mode

Battery Indications

TMT250 Battery Indication.PNG

Name Meaning
Charging Device is charging
Fully Charged Device is fully charged
Charging Error An error occurred while charging
Battery Low Device battery is low

Keyboard Indications

TMT250 Keyboard Indication.PNG

Name Meaning
Alarm Key Pressed Alarm button is pressed and held down
Alarm Key Action Activated Configured functionality was activated by pressed Alarm button
Alarm Key Action Deactivated Configured functionality was deactivated by pressed Alarm button
Power Key Pressed Power button is pressed and held down
Power Key Action Activated Configured functionality was activated by pressed Power button
Power Key Action Deactivated Configured functionality was deactivated by pressed Power button

Default Configuration LED indications

Name LED, Color & Additional indication
GSM Error GSM
No GPS Fix GNSS
GPS Fix GNSS
Device Off Battery, Vibration
Device On Battery, Vibration
I Am Alive GNSS
Charging Battery
Fully Charged Battery
Charging Error Battery
Battery Low Battery

Note! three LED colors are available - Green, Red and Blue. Indications are fully customizable depending on the user needs.

Retrieved from "https://wiki.teltonika-gps.com/index.php?title=TMT250_User_interface&oldid=84082"