Manual CAN Commands
From Wiki Knowledge Base | Teltonika GPS
Revision as of 11:57, 29 August 2023 by Maksim.jefisov (talk | contribs)
Main Page > Professional Trackers > FMC650 > FMC650 Configuration > Manual CAN Commands
To use Manual CAN commands functionality user should select Manual CAN Commands tab in Configurator. Afterwards, user will be able to configure CAN parameters in Manual CAN commands settings tab.
Manual CAN Commands
The main benefit, of using Manual CAN command functionality is that user is able to send data via CAN BUS without requiring additional CAN protocol development from the device's firmware side if vehicle should take an action with equipment connected via CAN line. To send command via CAN line with this functionality, the user must have:
FMC650/FMM650/FMB641 device
| NOTE! | 03.00.13.rev.05 or newer firmware (for FMC650/FMM650) |
NOTE! | 03.01.00.rev.00 or newer firmware for (FMB641/FMC650/FMM650) |
