FMC250 LED status
From Wiki Knowledge Base | Teltonika GPS
Revision as of 12:39, 30 April 2024 by Arnas.Zeb (talk | contribs) (Created page with "{{Template:FMB1 LED status|model=FMC250|CAN_status=}}==CAN Status LED indications== <table class="nd-othertables_2" style="width:60%;"> <tr> <th rowspan="1" style="w...")
Main Page > CAN Trackers & Adapters > FMC250 > FMC250 Manual > FMC250 LED status
This section is an explanation of LED indications on an FMC250 device.
| Behaviour | Meaning |
|---|---|
| Permanently switched on | GNSS signal is not received |
| Blinking every second | Normal mode, GNSS is working |
| Off | GNSS is turned off because: Device is not working or Device is in sleep mode |
| Blinking fast constantly | Device firmware is being flashed |
Status LED Indications
| Behaviour | Meaning |
|---|---|
| Blinking every second | Normal mode |
| Blinking every two seconds | Sleep mode |
| Blinking fast for a short time | Modem activity |
| Off | Device is not working or Device is in boot mode |
CAN Status LED indications
| Behaviour | Meaning |
|---|---|
| Blinking very fast | FW is being flashed for CAN IC |
| Fast blinking | The flashed FW image is corrupted or not found |
| Short blink and long wait | No CAN configuration uploaded in device |
| 2 short blinks and long wait | CAN configuration is loaded for parsing CAN data |
| 3 short blinks and long wait | Data is being read from CAN bus |
