Changes

no edit summary
Line 177: Line 177:     
[[File:Adas conf2.png|center|frameless|1000x1000px]]
 
[[File:Adas conf2.png|center|frameless|1000x1000px]]
 +
 +
==DSM configuration for FMx650==
 +
 +
'''(!) Required firmware version - 03.00.14.Rev.114'''. [[DSM_Firmware_errata|Firmware errata.]]
 +
 +
*Make sure '''Data Protocol''' is set to [[Codec#Codec_8_Extended | Codec 8 Extended]]
 +
 +
[[Image:Data_protocol.gif|300px]]
 +
 +
*In ''RS232 \ RS485 settings tab'', make sure to enable '''Camera interface''' by "Enable", and select '''DSM''' in the Mode drop-down menu, afterwards '''DSM COM1''' and '''Camera I/O''' should appear in the tab list.
 +
 +
[[Image:DSM config.gif|600px]]
 +
 +
*Make sure to change '''Camera I/O''' camera state '''Priorities''' to ''Low''
 +
'''
 +
[[File:DSM IO.gif|500px]]
 +
'''
 +
 +
*In appeared ''DSM COM1'' tab, make sure to '''configure everything by your needs''', and do not forget to complete the '''"Domain"''' and '''"Port"''' settings in ''File upload settings''
 +
 +
[[File:DSM COM1.png|500px]]
 +
 +
 +
*'''''NOTE:''''' ''This is a base setup for the device to work properly. Other device configuration is made according to your needs.
 +
 +
===Connecting two cameras simultaneously for FMx650===
 +
------------------
 +
The new feature for FMx650 DSM configuration, which is available from '''03.00.14.Rev.114 iCamera''' allows you to connect two of your cameras at once. Method for connection and configuration stays the same, for this you are only required to choose '''two''' cameras in '''"RS232 \ RS485"''' tab from the configurator.
 +
 +
In the new functionality, you are able to connect any combo of the cameras by your wish, as an example: you are able to connect ''DSM/Dualcam'', ''DashCam/DualCam'', ''DSM/DSM'', ''DualCam/DualCam'' and etc.
 +
 +
[[File:Twincamera.gif|500px]]
 +
    
==FMx125/FMX225 Configuration==
 
==FMx125/FMX225 Configuration==