EYE FUNCTIONALITIES

From Wiki Knowledge Base | Teltonika GPS

Page Description

This page will describe EYE device functionalities, their flow and functionality supporting software versions.

Functionalities

Connecting to the device
SW version requirements EYE APP: 1.2.0-60+

Firmware: 1.2.1.R.0 to 1.2.8.R.2

Step No. 1 2 3
Short step desc. Tap the selected device to connect to it Enter PIN Connected
Successful attempt at functionality visual
Short step desc. Tap the selected device to connect to it Enter PIN incorrectly Fail to enter PIN correctly 4 more times Wait for 5 min timeout and enter PIN incorrectly Fail to enter PIN correctly 4 more times
Additional desc. Device is locked for 5 min but will allow to connect with PIN again after timeout Device is locked for 5 min but will allow to connect with PIN again after timeout, thus this is continued in infinite loop.
Failed attempt at functionality visual




SW version requirements EYE APP: 1.2.0-60+

Firmware: 1.2.9.R.8+

Short step desc. Tap the selected device to connect to it Enter PIN incorrectly Fail to enter PIN correctly 4 more times Wait for 5 min timeout and enter PIN incorrectly Fail to enter PIN correctly 4 more times
Additional desc. Device is locked for 5 min but will allow to connect with PIN again after timeout Device is locked with PUK code now and will remain so until correct PUK is entered, see PUK code unlock.
Failed attempt at functionality visual
PUK code unlock
SW version requirements EYE APP: 1.2.0-60+

Firmware: 1.2.9.R.8+

Step No.
Short step desc. Tap the blocked device to connect to it Enter PUK Connected
Additional desc. PIN automatically resets to default
Successful attempt at functionality visual
Step desc. Tap the selected device to connect to it Enter PUK incorrectly Fail to enter PIN correctly 4 more times
Additional desc. PUK is rejected and you can only go back or enter correct PUK
Failed attempt at functionality visual


Hibernate mode:
Wake up:
SW version requirements Firmware: 1.2.9.R.8+
Step No. 1-3 4
Short step desc. Attach magnet to sleeping device and wait for LED to blink. Device starts broacasting
Additional desc. Now device is discoverabled, scannable, connectable via BLE.
Successful attempt at functionality visual 520746 Magnet EYE gif v1.6-min.gif
Send to sleep:
SW version requirements EYE APP: 1.2.0-60+

Firmware: 1.2.9.R.8+

Step No. 1 2 3
Short step desc. While connected and in overview tap "Send device to sleep" Confirm your selection Wait for EYE App to disconnect
Additional desc. Device is no longer connectable or findable until wake up step is performed.
Successful attempt at functionality visual