0
edits
Changes
FMB140 autoscan feature instructions (view source)
Revision as of 14:34, 20 March 2020
, 14:34, 20 March 2020no edit summary
'''Step 3.'''
'''Step 3.'''
After the connection is done successfully, launch the configurator and navigate to the CAN Adapter tab.
After the connection is done successfully, launch the configurator and navigate to the CAN Adapter tab.
Before clicking the Scan button, make sure that ignition is ON. FMB140 configured ignition source should be DIN1 or Power Voltage.
Before clicking the Scan button, make sure that ignition is ON. FMB140 configured ignition source should be DIN1 or Power Voltage.[[File:Autoscan config.png|center|1151x1151px]]After pressing the scan button configurator will wait up to 60 seconds for device to send up to 9
After pressing the scan button configurator will wait up to 60 seconds for device to send up to 9
program numbers. If timeout is reached configurator will display an error.
program numbers. If timeout is reached configurator will display an error.
If no CAN bus connection is detected, configurator will return an error after pressing the scan button.
If no CAN bus connection is detected, configurator will return an error after pressing the scan button.
