0
edits
Changes
FMB140 autoscan feature instructions (view source)
Revision as of 15:26, 26 March 2020
, 15:26, 26 March 2020no edit summary
'''Step 3.'''
'''Step 3.'''
After the connection is done successfully, launch the configurator and navigate to the CAN Adapter tab.
After the connection is done successfully, launch the configurator and navigate to the CAN Adapter tab.
Before clicking the Scan button, make sure that ignition is ON. FMB140 configured ignition source should be DIN1 or Power Voltage. Scan button will only be available if device is connected to the configurator.[[File:Autoscan config.png|center|1151x1151px]]After pressing the scan button configurator will wait up to 60 seconds for device to send up to 9
Before clicking the Scan button, make sure that ignition is ON. FMB140 configured ignition source should be DIN1 or Power Voltage. Scan button will only be available if device is connected to the configurator.
program numbers. If timeout is reached configurator will display an error.
[[File:Scanning.png|center|frameless|1129x1129px]]
If no CAN bus connection is detected, configurator will return an error after pressing the scan button.
After pressing the scan button configurator will wait up to 60 seconds for device to send up to 9 program numbers. If timeout is reached configurator will display an error.
If no CAN bus connection is detected, configurator will return an error after pressing the scan button.
If scanning through OBD-II port (diagnostic connector) goes unsuccessfully, try connecting CAN1L and CAN1H wires directly to vehicle CAN bus using Mini-CAN contactless reader.
After a successful scan, a list of compatible program numbers will be displayed. The first program number will be saved in device internal CAN chip and device configuration. Available parameters will be highlighted in green.
After a successful scan, a list of compatible program numbers will be displayed. The first program number will be saved in device internal CAN chip and device configuration.
You can try entering each of the scanned numbers into device configuration to see which parameters are available and which suggestion works best for the vehicle.
You can try entering each of the scanned numbers into device configuration to see which parameters are available and which suggestion works best for the vehicle.
[[File:Scan1.jpg|center|frameless|1091x1091px]]
==Autoscan on init feature==
== Autoscan on init feature ==
'''Autoscan on init feature is only available with FMB140 devices and does not work with external CAN adapters. Autoscan on init feature will only work with these conditions''':
'''Autoscan on init feature is only available with FMB140 devices and does not work with external CAN adapters. Autoscan on init feature will only work with these conditions''':
